Tugboat

Tugboat

The Tug Boat RDA clone, consists of a stainless steel construction with an aluminum cap, and a matching aluminum drip tip that is fitted with delrin plastic to dessipate heat. The top cap design has 2 pre-drilled holes in approximately 3/32 in size and engraved with a “tug boat” on one side and an American flag on the other. The deep well base is great to provide liquid consumption, and the 3 posts is great for simple to creative coil configuration setups. Three phillips screws is used to tighten and the post holes are large enough to fit thicker gauge wires. The 510 threaded connection is equipped with copper center contacts for excellent conductivity.

Description

  • 22mm diameter
  • Stainless steel base, aluminum cap/tip
  • Copper contact pin
  • Tri pole with juice well
  • Dual air holes 3/32
  • High temperature insulator
  • Deep juice well
  • Reduced chamber
  • Drip tip is fitted with plastic at the base for less heat travel to lips

Includes:

  • 1 x Tug Boat RDA clone
  • 1 x Matching drip tip
  • Extra O-Ring
  • Tool
  • Replacement screws
  • 2 x Pre-built micro coils

Note: It is strongly recommended to thoroughly wash & clean the atomizer. When using rebuildable atomizers, please have a clear knowledge and understanding of properly using these products.